Instructions for Lightning Counter Tester
1. Please charge before use. To ensure charging effectiveness and extend battery life, use the dedicated charger. It takes about 3-4 hours to fully charge an empty battery. The red light on the charger indicates charging; the green light indicates full charge.
2. According to the installation height of the counter, appropriately extend the telescopic discharge rod.
3. For the dedicated grounding wire, insert one end's plug into the jack at the rear of the tester, and connect the other end's clip to the ground.
4. Press the red button to supply high voltage for about 1 second. The indicator light will illuminate (flicker slightly).
Then gently touch the connection point between the counter and the lightning arrester to test.
5. After each touch, the tip of the discharge rod should be removed from the counter. If repeated testing is needed, do not release the button. Wait 1-2 seconds until the indicator light flickers again, then touch again for testing.
6. Continuous testing may cause the tester to heat up. Please allow appropriate intervals to reduce malfunctions and extend battery life.
7. The tester output has three levels: high, medium, and low, which can be adjusted via the toggle switch on the head to suit testing different types or brands of counters.
Lightning Counter Tester
1. Portable design, small size and light weight
2. Telescopic electrode adjustable in length
3. AC/DC dual power supply with built-in rechargeable battery; one charge can last for half a year
4. Strong anti-interference capability
5. Voltage 1500V
Lightning Counter Tester
1. Please charge before use. To ensure charging effectiveness and extend battery life, use the dedicated charger. It takes about 3-4 hours to fully charge an empty battery. The red light on the charger indicates charging.
2. According to the installation height of the counter, appropriately extend the telescopic discharge rod.
3. For the dedicated grounding wire, insert one end's plug into the jack at the rear of the tester, and connect the other end's clip to the ground.
4. Press the red button to supply high voltage for about 1 second. The indicator light will illuminate (flicker slightly). Then gently touch the connection point between the counter and the lightning arrester to test.
5. After each touch, the tip of the discharge rod should be removed from the counter. If repeated testing is needed, do not release the button. Wait 1-2 seconds until the indicator light flickers again, then touch again for testing.
6. Continuous testing may cause the tester to heat up. Please allow appropriate intervals to reduce malfunctions and extend battery life.
