Rod Type Discharge Counter Tester
Dary Electric recommends:
Overview of Rod Type Discharge Counter Tester:
1. Voltage: DC 900V, 1200V, 1600V three gears
2. Discharge current >100A/10US
II. Usage Method
.1. Charge before use. To ensure charging effect and extend battery life, use the dedicated charger. It takes 3-4 hours to fully charge an empty battery. The red light on the charger indicates charging; green light indicates charging complete. Before use, connect the attached ground wire plug at the tail end, and clamp the ground wire clip to the earth.
2. According to the installation height of the counter, appropriately extend the telescopic discharge rod.
3. Press the red button to turn on high voltage for about 1 second, the indicator light will be on (flickering slightly), then gently click the connection end of the counter and the arrester for testing.
4. After each click, the discharge rod tip should leave the counter. If repeated testing is needed, you may not release the button. After about 1-2 seconds, when the indicator light flashes again, you can click again for testing.
5. Continuous testing will cause the tester to heat up. Please allow appropriate intervals.
6. If the indicator light does not flash within 3 seconds after pressing the button, it indicates that the battery needs charging.
7. Do not disassemble the tester at will. If the battery capacity drops significantly or the charging efficiency is too low, it needs to be replaced. Please purchase the dedicated battery pack from our company.
<
