Desktop|中文
Home About Us Products + News Center Technical Articles Messages Contact Us

Product Details

全自动Dielectric Loss Tester-扬州达瑞

Lightning Counter Calibration Instrument - Yangzhou Darui

Published: 2020-08-13 16:45:23

Views: 2922

Category: Lightning Counter Calibrator

Product Description


Lightning Counter Calibration Instrument 

Darui Electric recommends:

Instructions:



1. Please charge before use. To ensure charging effectiveness and extend battery life, the Lightning Counter Calibration Instrument requires the dedicated charger. It takes about 3-4 hours to fully charge an empty battery. A red light on the charger indicates charging; a green light indicates full charge.

2. According to the installation height of the counter, appropriately extend the telescopic discharge rod.

3. For the dedicated grounding wire, insert one end's plug into the rear jack of the calibrator, and clamp the other end's clip to the ground.

4. Press the red button to turn on high voltage for about 1 second. The indicator light will illuminate (flicker slightly),

then you can gently tap the connection end between the counter and the arrester for testing.





5. After each tap, the discharge rod tip should be removed from the counter. If repeated testing is needed, do not release the button. Wait 1-2 seconds until the indicator light flickers again, then tap again for testing.

6. Continuous testing may cause the calibrator to heat up. Please allow appropriate intervals to reduce malfunctions and extend battery life.



7. The calibrator output has three levels: high, medium, and low, adjustable via the toggle switch on the head to accommodate testing of different types or brands of counters.

8. If the indicator light does not flicker after pressing the button for more than 3 seconds, the battery needs charging.

9. Do not disassemble the calibrator arbitrarily. If the battery pack capacity significantly drops or charging efficiency is too low, it needs replacement. Please purchase a dedicated battery pack from our company.



Product Features:

1. Portable design, small size and light weight

2. Telescopic electrode adjustable in length

3. AC/DC dual power supply with built-in rechargeable battery, one charge can last for half a year

4. Strong anti-interference capability

5. Maximum voltage 1500V



Technical Parameters:



1. Voltage: DC 900V, 1200V, 1600V three levels

2. Discharge current >100A/10US

3. Weight: 420g

4. Length: 450cm

5. Test interval time: 1 second

6. Test count: 300 times

7. Charging: 3~4 hours



Note: The above information and technical parameters are compiled and released by Yangzhou Darui Electric Co., Ltd.
WeChat QR Code
💬
💬 Message ✕

Hello! Have you found what you need? Contact us directly online!

Leave a Message for Consultation
Yangzhou Darui Electric Co., Ltd.
主营产品:Dielectric Loss Tester、Transformer Ratio测试仪、Loop Resistance Tester、高压None线核相仪、Insulation Resistance Tester、Partial Discharge Tester、Cable Fault Tester、DC Resistance Tester等。
☎ Phone: 18952707000(关经理)📞 Landline: 0514-88770377✉ Email: 195214804@qq.com
Verification Code
By submitting, you agree to ourTerms of ServiceandPrivacy Policy
🏠 网站Home📞 一键拨号✉ Contact Us